Flash a board#

Board

Image

How

ESP32-S3

the firmware on the latest release, or the 2.5.1b beta

the desktop app’s Flash firmware button, or idf.py flash from your own build

ESP-Mosaico

OpenCarMind-EdgeOS-2.1.0-ESP-Mosaico-ESP32-S31-merged.bin on the OpenCarMind EdgeOS 2.1.0 release

open the USB port at 1200 baud, then esptool 5.6.0 or later. No buttons

Check every image against the SHA256SUMS file next to it on the release page.

ESP32-S3#

Steps for the desktop app are in the manual chapter on updating. To build from source, follow ESP32-S3 board. If the board stays in download mode after flashing, reset it with python -m esptool --chip esp32s3 -p <port> --after watchdog-reset chip-id.

ESP-Mosaico#

You find the commands on ESP-Mosaico. Writing the merged image erases the NVS partition, so the pairing with the desktop app, the saved Wi-Fi networks and the settings go, and you pair again. Drive logs on the NAND are not written. The desktop app’s Flash firmware button is for the ESP32-S3 only, so do not use it for the ESP-Mosaico.