Wi-Fi sets the clock, and nothing else#
The board has no battery-backed clock chip, so Wi-Fi is how it learns the time. While the car is parked, it asks one HTTPS time server for the date and sets the clock. It sends nothing else. Drives come over the USB cable. There is no Wi-Fi upload.
Note
The radio runs only while you use it
Wi-Fi starts for a clock sync, a search or a join, and stops when that ends. A sync never starts during a drive. If one is running when a drive starts, it stops. This keeps memory free for the Bluetooth link to the adapter.
Note
No Wi-Fi in the first minute after a start
The first minute after a start is when the board has the least memory to spare, so it keeps Wi-Fi off until its health check (Health checks and messages). When the check says good or degraded, the automatic clock sync goes ahead. If the clock is not set yet, the first sync follows about 20 seconds later. When the check says bad, Wi-Fi stays off until you start it, and the events say “Wi-Fi held (boot health bad): start it in Wi-Fi”. Sync clock now, Search for networks and Join always work, at any time while parked.
Search and join#
Open Wi-Fi and tap Search for networks. The board lists up to 20 networks, strongest first, with signal bars and a padlock on secured ones.
For a secured network, tap it, type its password on the on-screen keyboard (8 to 64 characters, the eye shows what you typed), then tap Join.
For an open network, tap it. A confirm sheet warns that it has no password and that anyone nearby can read what it carries. Tap Join.
The board saves the network (up to 8), connects once and says what happened: connected, wrong password, or can’t reach it.
The board does not keep a wrong password for a new network. Network names show on the screen only and never in the board’s log.
A network you saved before#
In the search list it reads “Saved, secured” or “Saved, open”. Tap it. The Join page opens with “Saved password” in the field, so you do not type it again. Tap Join. To change the password, type a new one first.
To remove a network, tap Forget next to it under Saved networks. During a drive the board refuses and says “Not forgotten: a drive is running.” The desktop app can add networks too.
Networks it cannot join#
Enhanced-open (OWE) networks show as secured and ask for a password. WEP and WPA-TKIP-only networks end with “Can’t join: the board does not support this network’s security type.”