The board, an adapter and a card#
The parts#
Board: Waveshare ESP32-S3-LCD-1.47B
Adapter: a Bluetooth LE OBD-II adapter that speaks ELM327 commands, the common adapter command set
Card: a FAT-formatted SD card
Power: the car’s USB port
Why Bluetooth LE only#
The ESP32-S3 has no Classic Bluetooth radio, so Classic-only adapters will not pair. Check that your adapter’s listing says Bluetooth LE.
First boot#
The board connects to the strongest nearby device that looks like an OBD adapter and remembers it.
Planned for a later S3 release, off in this source by default (CONFIG_OBD_BLE_PAIR_CONFIRM): the board asks first. It offers only an adapter with a strong signal, -70 dBm or better, and shows “Use <name>?” with “Strong. Tap = use it” (or “Good” for a weaker signal). Tap BOOT within 5 seconds to pair it. If you do nothing, nothing is saved. Once paired, the adapter also connects at a weaker signal, down to -90 dBm.
Adapter |
Bluetooth |
Status |
|---|---|---|
LELink², LELink |
LE |
tested |
Veepeak OBDCheck BLE+, BLE |
LE |
expected |
OBDLink CX |
LE 5.1, encrypted |
expected |
Carista OBD2, Carista EVO |
LE |
expected |
Vgate iCar Pro BLE 4.0 |
LE |
expected |
Vgate vLinker MC+ |
LE and Classic |
expected |
Vgate vLinker FS, MS |
LE and Classic |
switch to “BLE+BT” in the VgateFwUpdater app first |
Panlong OBD2 Scanner (PL-B04) |
LE |
expected for the “For iOS Android” option only |
DA200 |
LE |
expected |
ELM327 BLE clones |
LE on iOS |
expected for most. Buy one whose listing says Bluetooth LE for iOS. |
Adapters running the Deep OBD firmware |
LE |
expected |
FIXD |
Bluetooth |
unverified |
BlueDriver |
Bluetooth, private protocol |
not expected |
V800 full-system scanners |
Bluetooth, private app |
not expected |
OBDLink MX+, OBDLink LX, KONNWEI KW902 |
Classic only |
will not work |
Only the LELink has been driven with this board. The other rows come from vendor documents and other open-source OBD projects.